The ESCR and OTAR registers exist in each DU channel, but at different
offsets for odd and even channels. This led to usage of the group
register access API to write them, with offsets macros named ESCR/OTAR
and ESCR2/OTAR2 for the first and second ESCR/OTAR register in the group
respectively.
The names are confusing as it suggests that the ESCR/OTAR registers for
DU0 and DU2 are taken into account, especially with writes performed to
the group register access API.
Rename the offsets to ESCR/OTAR02 and ESCR/OTAR13, and use the CRTC
register access API to clarify the code. The offsets values are updated
accordingly.
Cosmetic patch, no functional changes intended.
Signed-off-by: Jacopo Mondi <jacopo+renesas@jmondi.org>
Reviewed-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
[Squashed ESCR and OTAR changes in a single commit]
Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
The ODDF signal, output by default on the ODDF pin, isn't used on any
board supported in the kernel. As the Gen3 Salvator-X board uses the
ODDF pin as a DISP signal, hardcode that configuration in the driver.
Use of the ODDF signal will be implemented later through proper DT-based
configuration of the DU pins.
Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Configure the plane source at plane setup time to source frames from
memory or from the VSP1.
Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Accept interlaced modes on the VGA and HDMI connectors and configure the
hardware accordingly.
Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
The DU uses the module functional clock as the default pixel clock, but
supports using an externally supplied pixel clock instead. Support this
by adding the external pixel clock to the DT bindings, and selecting the
clock automatically at runtime based on the requested mode pixel
frequency.
The input clock pins to DU channels routing is configurable, but
currently hardcoded to connect input clock i to channel i.
Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
The DU revision in the R8A7790 SoC uses one IRQ and clock per CRTC. Add
a corresponding entry in the module platform ID table.
Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Channels are accessed through a global channel memory offset, there's no
need to define register addresses for the second channel.
Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
The R-Car Display Unit (DU) DRM driver supports both superposition
processors and all eight planes in RGB and YUV formats with alpha
blending.
Only VGA and LVDS encoders and connectors are currently supported.
Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Signed-off-by: Dave Airlie <airlied@redhat.com>
