Currently on all supported platforms the IPC IRQ thread first signals
the sender when an IPC response is received from the DSP, then unmasks
the IPC interrupt. Those actions are performed without holding any
locks, so the thread can be interrupted between them. IPC timeouts
have been observed in such scenarios: if the sender is woken up and it
proceeds with sending the next message without unmasking the IPC
interrupt, it can miss the next response. This patch takes a spin-lock
to prevent the IRQ thread from being preempted at that point. It also
makes sure, that the next IPC transmission by the host cannot take
place before the IRQ thread has finished updating all the required IPC
registers.
Fixes: 53e0c72d98 ("ASoC: SOF: Add support for IPC IO between DSP and Host")
Reviewed-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Guennadi Liakhovetski <guennadi.liakhovetski@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
When using a shared IRQ between IPC interrupt and stream IOC interrupt,
the interrupt handlers need to check the interrupt source before
scheduling their respective IRQ threads. In the case of IPC handler, it
should check if it is an IPC interrupt before waking up the IPC IRQ
thread.
The IPC IRQ thread, once scheduled, does not need to check the IRQ
source again. So, remove the superfluous check in the thread. Remove the
irq_status field from snd_sof_dev struct also as it is no longer needed.
Signed-off-by: Keyon Jie <yang.jie@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
