During init, there can be some collisions on the i2c bus that result in
the EEPROM read failing. This has been mitigated in the PMFW to a
degree, but there is still a small chance that the bus will be busy.
When the read fails during RAS init, that disables page retirement
altogether, which is obviously not ideal. To try to avoid that
situation, set the eeprom_read function to retry once if the first read
fails, specifically for smu_v13_0_6.
Signed-off-by: Kent Russell <kent.russell@amd.com>
Reviewed-by: Lijo Lazar <lijo.lazar@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
fix the pp_dpm_pcie issue on smu v14.0.2/3 as below:
0: 2.5GT/s, x4 250Mhz
1: 8.0GT/s, x4 616Mhz *
2: 8.0GT/s, x4 1143Mhz *
the middle level can be removed since it is always skipped on
smu v14.0.2/3
Signed-off-by: Kenneth Feng <kenneth.feng@amd.com>
Acked-by: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
No change in functionality for the current code, but we
need to set the index properly before changing it if we
ever use a non-0 index.
Reviewed-by: Kenneth Feng <kenneth.feng@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
The kernel doc says you need to select manual mode to
adjust this, but the code only allows you to adjust it when
manual mode is not selected. Remove the manual mode check.
Reviewed-by: Kenneth Feng <kenneth.feng@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Pull drm fixes from Dave Airlie:
"Regular weekly fixes. This is a bit larger than usual but doesn't seem
too crazy.
Most of it is vmwgfx changes that fix a bunch of issues with wayland
userspaces with dma-buf/external buffers and modesetting fixes.
Otherwise it's kinda spread out, v3d fixes some new ioctls, nouveau
has regression revert and fixes, amdgpu, i915 and ast have some small
fixes, and some core fixes spread about.
client:
- fix error code
atomic:
- allow damage clips with async flips
- allow explicit sync with async flips
kselftests:
- fix dmabuf-heaps test
panic:
- fix schedule_work in panic paths
panel:
- fix OrangePi Neo orientation
gpuvm:
- fix missing dependency
amdgpu:
- SMU 14.x update
- Fix contiguous VRAM handling for IB parsing
- GFX 12 fix
- Regression fix for old APUs
i915:
- Static analysis fix for int overflow
- Fix for HDCP2_STREAM_STATUS macro and removal of PWR_CLK_STATE for gen12
nouveau:
- revert busy wait change that caused a resume regression
- fix buffer placement fault on dynamic pm s/r
- fix refcount underflow
ast:
- fix black screen on resume
- wake during connector status detect
v3d:
- fix issues with perf/timestamp ioctls
vmwgfx:
- fix deadlock in dma-buf fence polling
- fix screen surface refcounting
- fix dumb buffer handling
- fix support for external buffers
- fix overlay with screen targets
- trigger modeset on screen moves"
* tag 'drm-fixes-2024-08-02' of https://gitlab.freedesktop.org/drm/kernel: (31 commits)
Revert "nouveau: rip out busy fence waits"
nouveau: set placement to original placement on uvmm validate.
drm/atomic: Allow userspace to use damage clips with async flips
drm/atomic: Allow userspace to use explicit sync with atomic async flips
drm/i915: Fix possible int overflow in skl_ddi_calculate_wrpll()
drm/i915/hdcp: Fix HDCP2_STREAM_STATUS macro
drm/ast: astdp: Wake up during connector status detection
i915/perf: Remove code to update PWR_CLK_STATE for gen12
kselftests: dmabuf-heaps: Ensure the driver name is null-terminated
drm/client: Fix error code in drm_client_buffer_vmap_local()
drm/amdgpu: Fix APU handling in amdgpu_pm_load_smu_firmware()
drm/amdgpu: increase mes log buffer size for gfx12
drm/amdgpu: fix contiguous handling for IB parsing v2
drm/amdgpu/pm: support gpu_metrics sysfs interface for smu v14.0.2/3
drm/vmwgfx: Trigger a modeset when the screen moves
drm/vmwgfx: Fix overlay when using Screen Targets
drm/vmwgfx: Add basic support for external buffers
drm/vmwgfx: Fix handling of dumb buffers
drm/vmwgfx: Make sure the screen surface is ref counted
drm/vmwgfx: Fix a deadlock in dma buf fence polling
...
We only had a couple of array[] declarations, and changing them to just
use 'MAX()' instead of 'max()' fixes the issue.
This will allow us to simplify our min/max macros enormously, since they
can now unconditionally use temporary variables to avoid using the
argument values multiple times.
Cc: David Laight <David.Laight@aculab.com>
Cc: Lorenzo Stoakes <lorenzo.stoakes@oracle.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Enables following UMD stable Pstates profile levels
of power_dpm_force_performance_level for SMU v14.0.4.
- profile_peak
- profile_min_mclk
- profile_min_sclk
- profile_standard
Signed-off-by: Li Ma <li.ma@amd.com>
Reviewed-by: Tim Huang <tim.huang@amd.com>
Acked-by: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
This was intended to add support for GFX IP v11.5.2, but it needs
to be applied to all GFX11 and subsequent APUs. Therefore the code
should be revised to accommodate this.
Signed-off-by: Tim Huang <tim.huang@amd.com>
Acked-by: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Why:
If the reg mmMP1_SMN_C2PMSG_90 is being written to during amdgpu driver
load or driver unload, subsequent amdgpu driver load will fail at
smu_hw_init. The default of mmMP1_SMN_C2PMSG_90 register at a clean
environment is 0x1 and if value differs from expected, amdgpu driver
load will fail.
How to fix:
Ignore the initial value in smu response register before the first smu
message is sent,if smc in SMU_FW_INIT state, just proceed further to
send the message. If register holds an unexpected value after smu message
was sent set, smc_state to SMU_FW_HANG state and no further smu messages
will be sent.
v2:
Set SMU_FW_INIT state at the start of smu hw_init/resume.
Check smc_fw_state before sending smu message if in hang state skip
sending message.
Set SMU_FW_HANG only in case unexpected value is detected
Signed-off-by: Danijel Slivka <danijel.slivka@amd.com>
Reviewed-by: Kenneth Feng <kenneth.feng@amd.com>
Reviewed-by: Lijo Lazar <lijo.lazar@amd.com>
Reviewed-by: Asad Kamal <asad.kamal@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
V1: This patch enables following UMD stable Pstates profile
levels for power_dpm_force_performance_level interface.
- profile_peak
- profile_min_mclk
- profile_min_sclk
- profile_standard
V2: Fix conflict with commit "drm/amd/pm: smu v14.0.4 reuse smu v14.0.0 dpmtable "
V3: Add VCLK1 and DCLK1 support for SMU V14.0.1
And avoid to set VCLK1 and DCLK1 for SMU v14.0.0
Signed-off-by: Li Ma <li.ma@amd.com>
Reviewed-by: Tim Huang <tim.huang@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
The exynos-next pull is based on a newer -rc than drm-next. hence
backmerge first to make sure the unrelated conflicts we accumulated
don't end up randomly in the exynos merge pull, but are separated out.
Conflicts are all benign: Adjacent changes in amdgpu and fbdev-dma
code, and cherry-pick conflict in xe.
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
commit cd94d1b182 ("dm/amd/pm: Fix problems with reboot/shutdown for
some SMU 13.0.4/13.0.11 users") attempted to fix shutdown issues
that were reported since commit 31729e8c21 ("drm/amd/pm: fixes a
random hang in S4 for SMU v13.0.4/11") but caused issues for some
people.
Adjust the workaround flow to properly only apply in the S4 case:
-> For shutdown go through SMU_MSG_PrepareMp1ForUnload
-> For S4 go through SMU_MSG_GfxDeviceDriverReset and
SMU_MSG_PrepareMp1ForUnload
Reported-and-tested-by: lectrode <electrodexsnet@gmail.com>
Closes: https://github.com/void-linux/void-packages/issues/50417
Cc: stable@vger.kernel.org
Fixes: cd94d1b182 ("dm/amd/pm: Fix problems with reboot/shutdown for some SMU 13.0.4/13.0.11 users")
Reviewed-by: Tim Huang <Tim.Huang@amd.com>
Signed-off-by: Mario Limonciello <mario.limonciello@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Support for I2C_CLASS_SPD is currently being removed from the kernel.
Only remaining step is to remove the definition of I2C_CLASS_SPD.
Setting I2C_CLASS_SPD in a driver is a no-op meanwhile, so remove it
here.
Reviewed-by: Alex Deucher <alexander.deucher@amd.com>
Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
commit cd94d1b182 ("dm/amd/pm: Fix problems with reboot/shutdown for
some SMU 13.0.4/13.0.11 users") attempted to fix shutdown issues
that were reported since commit 31729e8c21 ("drm/amd/pm: fixes a
random hang in S4 for SMU v13.0.4/11") but caused issues for some
people.
Adjust the workaround flow to properly only apply in the S4 case:
-> For shutdown go through SMU_MSG_PrepareMp1ForUnload
-> For S4 go through SMU_MSG_GfxDeviceDriverReset and
SMU_MSG_PrepareMp1ForUnload
Reported-and-tested-by: lectrode <electrodexsnet@gmail.com>
Closes: https://github.com/void-linux/void-packages/issues/50417
Cc: stable@vger.kernel.org
Fixes: cd94d1b182 ("dm/amd/pm: Fix problems with reboot/shutdown for some SMU 13.0.4/13.0.11 users")
Reviewed-by: Tim Huang <Tim.Huang@amd.com>
Signed-off-by: Mario Limonciello <mario.limonciello@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Remove gpu_metrics_v1_6 usage for SMUv13.0.6 temporarily and use
gpu_metrics_v1_5 until tool support is ready for it.
This reverts commit 74ab6253dc.
Signed-off-by: Asad Kamal <asad.kamal@amd.com>
Reviewed-by: Lijo Lazar <lijo.lazar@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
MinGfxClk in Dpmclocks_t is wrong. According to pmfw,
dropping an uint8_t spare in Dpmclocks_t.
Signed-off-by: Li Ma <li.ma@amd.com>
Reviewed-by: Yifan Zhang <yifan1.zhang@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
