[why]
There is only a single call to dc_post_update_surfaces_to_stream
so there is no need to have two flags to control it. Unifying
this to a single flag allows dc_stream_adjust_vmin_vmax to skip
actual programming when there is no change required.
[how]
Remove wm_optimze_required flag and set only optimize_required in its
place. Then in dc_stream_adjust_vmin_vmax, check that the stream timing
range matches the requested one and skip programming if they are equal.
Reviewed-by: Alvin Lee <alvin.lee2@amd.com>
Acked-by: Tom Chung <chiahsuan.chung@amd.com>
Signed-off-by: Aric Cyr <aric.cyr@amd.com>
Tested-by: Daniel Wheeler <daniel.wheeler@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
[why]
Originally, PMFW said min FCLK is 300Mhz, but min DCFCLK can be increased
to 400Mhz because min FCLK is now 600Mhz so FCLK >= 1.5 * DCFCLK hardware
requirement will still be satisfied. Increasing min DCFCLK addresses
underflow issues (underflow occurs when phantom pipe is turned on for some
Sub-Viewport configs).
[how]
Increasing DCFCLK by raising the min_dcfclk_mhz
Reviewed-by: Chaitanya Dhere <chaitanya.dhere@amd.com>
Reviewed-by: Alvin Lee <alvin.lee2@amd.com>
Acked-by: Tom Chung <chiahsuan.chung@amd.com>
Signed-off-by: Sohaib Nadeem <sohaib.nadeem@amd.com>
Tested-by: Daniel Wheeler <daniel.wheeler@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
[Why]
We want acknowledgment of the driver idle disallow from DMCUB before
continuing with any further programming.
For idle allow we want to minimize the chance of DMCUB actively
interacing with other firmware components on the system (eg. PMFW)
at the same time.
[How]
Ensure that DMCUB isn't in the middle of processing other command
submissions prior to allowing idle and after disallowing idle by
inserting a wait before the allow and by changing the wait type for
the idle disallow.
Reviewed-by: Charlene Liu <charlene.liu@amd.com>
Acked-by: Tom Chung <chiahsuan.chung@amd.com>
Signed-off-by: Nicholas Kazlauskas <nicholas.kazlauskas@amd.com>
Tested-by: Daniel Wheeler <daniel.wheeler@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Partial migration to system memory should use migrate.addr, not
prange->start as virtual address to allocate system memory page.
Fixes: a546a27684 ("drm/amdkfd: Use partial migrations/mapping for GPU/CPU page faults in SVM")
Signed-off-by: Philip Yang <Philip.Yang@amd.com>
Reviewed-by: Xiaogang Chen <Xiaogang.Chen@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
This patch is to eliminate interrupt warning below:
"[drm] Fence fallback timer expired on ring sdma0.0".
An early vm pt clearing job is sent to SDMA ahead of interrupt enabled.
And re-locating the drm client creation following after drm_dev_register
looks like a more proper flow.
v2: wrap the drm client creation
Fixes: 1819200166 ("drm/amdkfd: Export DMABufs from KFD using GEM handles")
Signed-off-by: Le Ma <le.ma@amd.com>
Reviewed-by: Felix Kuehling <felix.kuehling@amd.com>
Reviewed-by: Lijo Lazar <lijo.lazar@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
The 'stream' pointer is used in dcn10_set_output_transfer_func() before
the check if 'stream' is NULL.
Fixes the below:
drivers/gpu/drm/amd/amdgpu/../display/dc/hwss/dcn10/dcn10_hwseq.c:1892 dcn10_set_output_transfer_func() warn: variable dereferenced before check 'stream' (see line 1875)
Fixes: ddef02de0d ("drm/amd/display: add null checks before logging")
Cc: Wyatt Wood <wyatt.wood@amd.com>
Cc: Anthony Koo <Anthony.Koo@amd.com>
Cc: Rodrigo Siqueira <Rodrigo.Siqueira@amd.com>
Cc: Aurabindo Pillai <aurabindo.pillai@amd.com>
Signed-off-by: Srinivasan Shanmugam <srinivasan.shanmugam@amd.com>
Reviewed-by: Anthony Koo <Anthony.Koo@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
[Why]
IPS was temporary disabled due to instability.
It was fixed in dmub firmware and with:
- "drm/amd/display: Add IPS checks before dcn register access"
- "drm/amd/display: Disable ips before dc interrupt setting"
[How]
Enable IPS by default.
Disable IPS if 0x800 bit set in amdgpu.dcdebugmask module params
Signed-off-by: Roman Li <Roman.Li@amd.com>
Tested-by: Mark Broadworth <mark.broadworth@amd.com>
Reviewed-by: Mario Limonciello <mario.limonciello@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
[Why]
While in IPS2 an access to dcn registers is not allowed.
If interrupt results in dc call, we should disable IPS.
[How]
Safeguard register access in IPS2 by disabling idle optimization
before calling dc interrupt setting api.
Signed-off-by: Roman Li <Roman.Li@amd.com>
Tested-by: Mark Broadworth <mark.broadworth@amd.com>
Reviewed-by: Mario Limonciello <mario.limonciello@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
[Why]
Because ABM will wait VStart to start getting histogram data,
it will cause we can't enter IPS while full screnn video playing.
[How]
Modify the panel refresh rate to the maximun multiple of current
refresh rate.
Reviewed-by: Dennis Chan <dennis.chan@amd.com>
Acked-by: Roman Li <roman.li@amd.com>
Signed-off-by: ChunTao Tso <chuntao.tso@amd.com>
Tested-by: Daniel Wheeler <daniel.wheeler@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
[Why]
With IPS enabled a system hangs once PSR is active.
PSR active triggers transition to IPS2 state.
While in IPS2 an access to dcn registers results in hard hang.
Existing check doesn't cover for PSR sequence.
[How]
Safeguard register access by disabling idle optimization in atomic commit
and crtc scanout. It will be re-enabled on next vblank.
Reviewed-by: Nicholas Kazlauskas <nicholas.kazlauskas@amd.com>
Acked-by: Roman Li <roman.li@amd.com>
Signed-off-by: Roman Li <roman.li@amd.com>
Tested-by: Daniel Wheeler <daniel.wheeler@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
[Why & How]
Add regkey to block video playback in IPS2 by default
Allow idle optimizations in the same spot we allow Replay for
video playback usecases.
Avoid sending it when there's an external display connected by
modifying the allow idle checks to check for active non-eDP screens.
Reviewed-by: Charlene Liu <charlene.liu@amd.com>
Acked-by: Alex Hung <alex.hung@amd.com>
Signed-off-by: Nicholas Kazlauskas <nicholas.kazlauskas@amd.com>
Tested-by: Daniel Wheeler <daniel.wheeler@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
This needs to be set to 1 to avoid a potential deadlock in
the GC 10.x and newer. On GC 9.x and older, this needs
to be set to 0. This can lead to hangs in some mixed
graphics and compute workloads. Updated firmware is also
required for AQL.
Reviewed-by: Feifei Xu <Feifei.Xu@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org
This needs to be set to 1 to avoid a potential deadlock in
the GC 10.x and newer. On GC 9.x and older, this needs
to be set to 0. This can lead to hangs in some mixed
graphics and compute workloads. Updated firmware is also
required for AQL.
Reviewed-by: Feifei Xu <Feifei.Xu@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org
The power source flag should be updated when
[1] System receives an interrupt indicating that the power source
has changed.
[2] System resumes from suspend or runtime suspend
Signed-off-by: Ma Jun <Jun.Ma2@amd.com>
Reviewed-by: Lijo Lazar <lijo.lazar@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org
The 'status' variable in 'core_link_read_dpcd()' &
'core_link_write_dpcd()' was uninitialized.
Thus, initializing 'status' variable to 'DC_ERROR_UNEXPECTED' by default.
Fixes the below:
drivers/gpu/drm/amd/amdgpu/../display/dc/link/protocols/link_dpcd.c:226 core_link_read_dpcd() error: uninitialized symbol 'status'.
drivers/gpu/drm/amd/amdgpu/../display/dc/link/protocols/link_dpcd.c:248 core_link_write_dpcd() error: uninitialized symbol 'status'.
Cc: stable@vger.kernel.org
Cc: Jerry Zuo <jerry.zuo@amd.com>
Cc: Jun Lei <Jun.Lei@amd.com>
Cc: Wayne Lin <Wayne.Lin@amd.com>
Cc: Aurabindo Pillai <aurabindo.pillai@amd.com>
Cc: Rodrigo Siqueira <Rodrigo.Siqueira@amd.com>
Cc: Hamza Mahfooz <hamza.mahfooz@amd.com>
Signed-off-by: Srinivasan Shanmugam <srinivasan.shanmugam@amd.com>
Reviewed-by: Rodrigo Siqueira <Rodrigo.Siqueira@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
In a non-FLR page avoidance scenario, the host driver will
provide the bad pages in the pf2vf exchange region.
Adding a new host response message to indicate when the
pf2vf exchange region has been updated.
Signed-off-by: Victor Skvortsov <victor.skvortsov@amd.com>
Reviewed-by: Hawking Zhang <Hawking.Zhang@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
[Why]
IPS was temporary disabled due to instability.
It was fixed in dmub firmware and with:
- "drm/amd/display: Add IPS checks before dcn register access"
- "drm/amd/display: Disable ips before dc interrupt setting"
[How]
Enable IPS by default.
Disable IPS if 0x800 bit set in amdgpu.dcdebugmask module params
Signed-off-by: Roman Li <Roman.Li@amd.com>
Tested-by: Mark Broadworth <mark.broadworth@amd.com>
Reviewed-by: Mario Limonciello <mario.limonciello@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
[Why]
While in IPS2 an access to dcn registers is not allowed.
If interrupt results in dc call, we should disable IPS.
[How]
Safeguard register access in IPS2 by disabling idle optimization
before calling dc interrupt setting api.
Signed-off-by: Roman Li <Roman.Li@amd.com>
Tested-by: Mark Broadworth <mark.broadworth@amd.com>
Reviewed-by: Mario Limonciello <mario.limonciello@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
- move aca init/fini function into ras init/fini to adapt gpu reset
sequence.
- add new function amdgpu_aca_reset()
Signed-off-by: Yang Wang <kevinyang.wang@amd.com>
Reviewed-by: Hawking Zhang <Hawking.Zhang@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
The driver unload hangs because the page retirement
kthread cannot be stopped as it is sleeping and waiting
on page retirement event to occur. Add kthread_should_stop()
to the event condition to wake up the kthread when kthread
stop is called during driver unload.
Fixes: 3fdcd0a31d ("drm/amdgpu: Prepare for asynchronous processing of umc page retirement")
Signed-off-by: Mukul Joshi <mukul.joshi@amd.com>
Reviewed-by: Hawking Zhang <Hawking.Zhang@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
