Add support for DLVR (Digital Linear Voltage Regulator) attributes,
which can be used to control RFIM.
Here instead of "fivr" another directory "dlvr" is created with DLVR
attributes:
/sys/bus/pci/devices/0000:00:04.0/dlvr
├── dlvr_freq_mhz
├── dlvr_freq_select
├── dlvr_hardware_rev
├── dlvr_pll_busy
├── dlvr_rfim_enable
└── dlvr_spread_spectrum_pct
└── dlvr_control_mode
└── dlvr_control_lock
Attributes
dlvr_freq_mhz (RO):
Current DLVR PLL frequency in MHz.
dlvr_freq_select (RW):
Sets DLVR PLL clock frequency.
dlvr_hardware_rev (RO):
DLVR hardware revision.
dlvr_pll_busy (RO):
PLL can't accept frequency change when set.
dlvr_rfim_enable (RW):
0: Disable RF frequency hopping, 1: Enable RF frequency hopping.
dlvr_control_mode (RW):
Specifies how frequencies are spread. 0: Down spread, 1: Spread in Center.
dlvr_control_lock (RW):
1: future writes are ignored.
dlvr_spread_spectrum_pct (RW)
A write to this register updates the DLVR spread spectrum percent value.
Signed-off-by: Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com>
[ rjw: Subject edits ]
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
It is possible that the system manufacturer locks down thermal tuning
beyond what is usually done on the given platform. In that case user
space calibration tools should not try to adjust the thermal
configuration of the system.
To allow user space to check if that is the case, add a new sysfs
attribute "production_mode" that will be present when the ACPI DCFG
method is present under the INT3400 device object in the ACPI Namespace.
Signed-off-by: Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com>
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
