The RING_INT_SRC_RPT_PTR register points to a cacheline in memory
to which an engine must report as source of interrupt prior to
generating an interrupt to the host.
The RING_INT_STATUS_RPT_PTR register points to the first cacheline
of the Interrupt Status Report (ISR) page (4KB) in graphics memory
to which all engines report their interrupt status.
The RING_IMR register has the interrupt enables and interrupt masks
for an engine.
We will refer to these registers shortly.
Bspec: 45963, 45964, 45965
Reviewed-by: Matt Roper <matthew.d.roper@intel.com>
Link: https://lore.kernel.org/r/20231214185955.1791-3-michal.wajdeczko@intel.com
Signed-off-by: Michal Wajdeczko <michal.wajdeczko@intel.com>
This workaround applies to graphics 20.04 on all engines.
Workaround has three parts :
1. Pipe flush before MI_ATOMIC - This part isn't relevant to Xe
(at least not right now) since we don't use MI_ATOMIC anywhere
in the kernel mode driver.
2. Memory-based interrupt masking - Memory-based interrupt processing
isn't supported on physical functions, only virtual functions,
according to bspec 60352. So this is probably only relevant once
SRIOV support lands in the driver.
3. Disabling CSB/timestamp updates to the ghwsp and pphwsp - Workaround
is added by this change.
The CSB reports to gHWSP and ppHWSP have been discussed as part
of a different topic on some internal threads and we've confirmed
that neither the KMD nor the GuC firmware use those for anything,
so disabling them is always "safe" and should have no functional
or performance impact on system operation. The same is true for
the timestamp updates in the ppHWSP as well. Given that, it might
make sense to just combine these two workarounds into a single
record (and single patch) and apply it on all steppings. Disabling
the reports for RCS on higher steppings doesn't have any kind of
negative impact and will simplify the overall situation.
V3(MattR):
- Combine WA apply same WA for all engines, no performance impact
V2(MattR):
- Mention detail in commit message
- Reorder bit define
- Improve bit naming
- Remove workaround part which isnt relevant
Reviewed-by: Matt Roper <matthew.d.roper@intel.com>
Signed-off-by: Tejas Upadhyay <tejas.upadhyay@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
This workaround applies to Xe2_LPM
V3(MattR):
- Reorder reg and wa placement
- Add base parameter to reg macro for better definition
V2(MattR):
- Change name of register
- Loop for all engines
- Driver permanent WA, applies to all steps
Reviewed-by: Matt Roper <matthew.d.roper@intel.com>
Signed-off-by: Tejas Upadhyay <tejas.upadhyay@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
It was reading (base) + 0x8c but that is not a valid register
and instead it should read (base) + 0x68.
So here reading the correct register and removing the wrong and
duplicated.
Reviewed-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
Signed-off-by: José Roberto de Souza <jose.souza@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
Wa_16017236439 requires that we update BCS_SWCTRL
(via indirect context batch buffer) to set 64B
transfers when running on an even-numbered BCS
engine and 256B on an odd-numbered BCS engine.
v2: Move WA from engine_was[] to lrc_was[]
Reviewed-by: Matt Roper <matthew.d.roper@intel.com>
Signed-off-by: Tejas Upadhyay <tejas.upadhyay@intel.com>
Signed-off-by: Niranjana Vishwanathapura <niranjana.vishwanathapura@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
copy cs instructions that dont have a explict MOCS field will use this
default MOCS value.
v2:
- move to xe_hw_engine.c
- remove BLIT_CCTL auxiliary macros
- removed MASKED_REG
v3:
- rebased
v4:
- process workaround in hwe->reg_lrc
v5:
- add a new function and call it from xe_gt_record_default_lrcs()
because hwe->reg_lrc is initialized later
BSpec: 45807
Cc: Matt Roper <matthew.d.roper@intel.com>
Signed-off-by: José Roberto de Souza <jose.souza@intel.com>
Reviewed-by: Matt Roper <matthew.d.roper@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
CS instructions that dont have a explicit MOCS field will use this
default MOCS value.
To do this, it was necessary to initialize part of the mocs earlier
and add new function that loads another array of rtp entries set
during run-time.
This is still missing to handle of mocs read for platforms with
HAS_L3_CCS_READ(aka PVC).
v2:
- move to xe_hw_engine.c
- remove CMD_CCTL auxiliary macros
v3:
- rebased
Bspec: 45826
Cc: Matt Roper <matthew.d.roper@intel.com>
Signed-off-by: José Roberto de Souza <jose.souza@intel.com>
Reviewed-by: Matt Roper <matthew.d.roper@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
These should replace the _MMIO() and MCR_REG() from i915, with the goal
of being more extensible, allowing to pass the additional fields for
struct xe_reg and struct xe_reg_mcr. Replace all uses of _MMIO() and
MCR_REG() in xe.
Since the RTP, reg-save-restore and WA infra are not ready to use the
new type, just undef the macro like was done for the i915 types
previously. That conversion will come later.
v2: Remove MEDIA_SOFT_SCRATCH_COUNT/MEDIA_SOFT_SCRATCH re-added by
mistake (Matt Roper)
Reviewed-by: Matt Roper <matthew.d.roper@intel.com>
Link: https://lore.kernel.org/r/20230427223256.1432787-8-lucas.demarchi@intel.com
Signed-off-by: Lucas De Marchi <lucas.demarchi@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
Convert the macro declarations to the equivalent GENMASK and
and bitfield prep for all registers.
v2 (Matt Roper):
- Fix wrong conversion of RPM_CONFIG0_CRYSTAL_CLOCK_FREQ_MASK
- Reorder fields of XEHP_SLICE_UNIT_LEVEL_CLKGATE for consistency
- Simplify CTC_SOURCE_* by only defining CTC_SOURCE_DIVIDE_LOGIC
as REG_BIT(0)
v3: Also remove DOP_CLOCK_GATE_ENABLE that is unused and wrongly defined
Reviewed-by: Matt Atwood <matthew.s.atwood@intel.com>
Link: https://lore.kernel.org/r/20230427223256.1432787-4-lucas.demarchi@intel.com
Signed-off-by: Lucas De Marchi <lucas.demarchi@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
The defines for the registers were brought over from i915 while
bootstrapping the driver. As xe supports TGL and later only, it doesn't
make sense to keep the GEN* prefixes and suffixes in the registers: TGL
is graphics version 12, previously called "GEN12". So drop the prefix
everywhere.
v2:
- Also drop _TGL suffix and reword commit message as suggested
by Matt Roper. While at it, rename VSUNIT_CLKGATE_DIS_TGL to
VSUNIT_CLKGATE2_DIS with the additional "2", so it doesn't clash
with the define for the other register
Reviewed-by: Matt Roper <matthew.d.roper@intel.com>
Link: https://lore.kernel.org/r/20230427223256.1432787-3-lucas.demarchi@intel.com
Signed-off-by: Lucas De Marchi <lucas.demarchi@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
On xe_hw_engine_print_state we were printing:
value_of(0x510) + 4 instead of
value_of(0x514) as desired.
So, let's properly define a RING_EXECLIST_SQ_CONTENTS_HI
register to fix the issue and also to avoid other issues
like that.
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
Reviewed-by: Lucas De Marchi <lucas.demarchi@intel.com>
Reduce the use of i915_reg_defs.h so it can be encapsulated in a single
place.
1) If it was being included by mistake, remove
2) If it was included for FIELD_GET()/FIELD_PREP()/GENMASK() and the
like, just include <linux/bitfield.h>
3) If it was included to be able to define additional registers, move
the registers to the relavant headers (regs/xe_regs.h or
regs/xe_gt_regs.h)
v2:
- Squash commit fixing i915_reg_defs.h include and with the one
introducing regs/xe_reg_defs.h
- Remove more cases of i915_reg_defs.h being used when all it was
needed was linux/bitfield.h (Matt Roper)
- Move some registers to the corresponding regs/*.h file (Matt Roper)
Signed-off-by: Lucas De Marchi <lucas.demarchi@intel.com>
Reviewed-by: Matt Roper <matthew.d.roper@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
[Rodrigo squashed here the removal of the i915 include]
Create regs/xe_engine_regs.h file with all the registers and bit
definitions used by the xe driver. Eventually the registers may be
defined in a different way and since xe doesn't supported below gen12,
the number of registers touched is much smaller, so create a new header.
The definitions themselves are direct copy from the
gt/intel_engine_regs.h file, just sorting the registers by address.
Cleaning those up and adhering to a common coding style is left for
later.
Signed-off-by: Lucas De Marchi <lucas.demarchi@intel.com>
Reviewed-by: Matt Roper <matthew.d.roper@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
