Handle also I3C address header error response status as the end of DAA
process in hci_cmd_v1_daa().
According to MIPI I3C HCI Specification v1.1 the NACK error during DAA
process comes when the device does not accept the dynamic address.
Currently code uses it for successful exit from the process and fails
with any other error response.
I'm unsure is this MIPI I3C HCI version specific difference or
specification misunderstanding but on an early MIPI I3C HCI version
compatible controller responds always with I3C address header error and
not with NACK error when there is no device on the bus or no more devices
participating to DAA process.
Handle now both response statuses as the end of DAA.
Signed-off-by: Jarkko Nikula <jarkko.nikula@linux.intel.com>
Link: https://lore.kernel.org/r/20231109133708.653950-4-jarkko.nikula@linux.intel.com
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
This adds basic support for hardware implementing the MIPI I3C HCI
specification. This driver is currently limited by the capabilities
of the I3C subsystem, meaning things like scheduled commands,
auto-commands and NCM mode are not yet supported.
This supports version 1.0 of the MIPI I3C HCI spec, as well as the
imminent release of version 1.1. Support for draft version 2.0 of the
spec is also largely included with the caveat that future adjustments
to this code are likely as the spec is still a work in progress.
This is also lightly tested as actual hardware is still very scarce,
even for HCI v1.0. Hence the EXPERIMENTAL tag. Further contributions
to this driver are expected once vendor implementations and new I3C
devices become available.
Signed-off-by: Nicolas Pitre <npitre@baylibre.com>
Signed-off-by: Boris Brezillon <boris.brezillon@collabora.com>
Link: https://lore.kernel.org/linux-i3c/20201111220510.3622216-3-nico@fluxnic.net
