Allow user to override the default driver timeout for controller ready.
There are some rare configurations which require the driver to wait longer
than the normal 3 minutes for the controller to complete its bootup
sequence and be ready to accept commands from the driver.
The module parameter is:
ctrl_ready_timeout= { 0 | 30-1800 }
and specifies the timeout in seconds for the driver to wait for controller
ready. The valid range is 0 or 30-1800. The default value is 0, which
causes the driver to use a timeout of 180 seconds (3 minutes).
Link: https://lore.kernel.org/r/165730607666.177165.9221211345284471213.stgit@brunhilda
Reviewed-by: Scott Teel <scott.teel@microchip.com>
Reviewed-by: Mike McGowen <mike.mcgowen@microchip.com>
Signed-off-by: Kevin Barnett <kevin.barnett@microchip.com>
Signed-off-by: Don Brace <don.brace@microchip.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
Correct kdump hangs when controller is locked up.
There are occasions when a controller reboot (controller soft reset) is
issued when a controller firmware crash dump is in progress.
This leads to incomplete controller firmware crash dump:
- When the controller crash dump is in progress, and a kdump is initiated,
the driver issues inbound doorbell reset to bring back the controller in
SIS mode.
- If the controller is in locked up state, the inbound doorbell reset does
not work causing controller initialization failures. This results in the
driver hanging waiting for SIS mode.
To avoid an incomplete controller crash dump, add in a controller crash
dump handshake:
- Controller will indicate start and end of the controller crash dump by
setting some register bits.
- Driver will look these bits when a kdump is initiated. If a controller
crash dump is in progress, the driver will wait for the controller crash
dump to complete before issuing the controller soft reset then complete
driver initialization.
Link: https://lore.kernel.org/r/20210928235442.201875-3-don.brace@microchip.com
Reviewed-by: Scott Benesh <scott.benesh@microchip.com>
Reviewed-by: Scott Teel <scott.teel@microchip.com>
Reviewed-by: Mike McGowen <mike.mcgowen@microchip.com>
Acked-by: John Donnelly <john.p.donnelly@oracle.com>
Signed-off-by: Mahesh Rajashekhara <mahesh.rajashekhara@microchip.com>
Signed-off-by: Don Brace <don.brace@microchip.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
- when OFA event occurs, driver will stop traffic to RAID/HBA path. Driver
waits for all the outstanding requests to complete.
- Driver sends OFA event acknowledgment to firmware.
- Driver will wait until the new firmware is up and running.
- Driver will free up the resources.
- Driver calls SIS/PQI initialization and rescans the device list.
- Driver will resume the traffic to RAID/HBA path.
Reviewed-by: Murthy Bhat <murthy.bhat@microsemi.com>
Signed-off-by: Mahesh Rajashekhara <mahesh.rajashekhara@microsemi.com>
Signed-off-by: Don Brace <don.brace@microsemi.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
