Each of the powerpc selftests runs with a timeout of 2 minutes by
default (see tools/testing/selftests/powerpc/harness.c).
But when tests are run with run_kselftest.sh it uses a timeout of 45
seconds, meaning some tests run OK standalone but fail when run with the
test runner.
So tell run_kselftest.sh to give each test 130 seconds, that should
allow the tests to complete, or be killed by the powerpc test harness
after 2 minutes. If for some reason the harness fails, or for the few
tests that don't use the harness, the 130 second timeout should catch
them if they get stuck.
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
Link: https://patch.msgid.link/20241106130453.1741013-2-mpe@ellerman.id.au
Build breaks when executing make with run_tests for sub-folders
under powerpc. This is because, CFLAGS and GIT_VERSION macros are
defined in Makefile of toplevel powerpc folder.
make: Entering directory '/home/maddy/linux/tools/testing/selftests/powerpc/mm'
gcc hugetlb_vs_thp_test.c ../harness.c ../utils.c -o /home/maddy/selftest_output//hugetlb_vs_thp_test
hugetlb_vs_thp_test.c:6:10: fatal error: utils.h: No such file or directory
6 | #include "utils.h"
| ^~~~~~~~~
compilation terminated.
Fix this by adding the flags.mk in each sub-folder Makefile. Also remove
the CFLAGS and GIT_VERSION macros from powerpc/ folder Makefile since
the same is definied in flags.mk
Signed-off-by: Madhavan Srinivasan <maddy@linux.ibm.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
Link: https://msgid.link/20240229093711.581230-3-maddy@linux.ibm.com
In some powerpc/ sub-folder Makefiles, CFLAGS are defined before lib.mk
include. Clean it up by re-ordering the flags to follow after the mk
include. This is needed to support sub-folders in powerpc/ buildable on
its own.
Signed-off-by: Madhavan Srinivasan <maddy@linux.ibm.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
Link: https://msgid.link/20240229093711.581230-1-maddy@linux.ibm.com
ERR_NX_TRANSLATION(CSB.CC=5) is for internal to VAS for fault handling
and should not used by OS. ERR_NX_AT_FAULT(CSB.CC=250) is the proper
error code should be reported by OS when NX encounters address
translation failure.
This patch uses CC=250 to determine the fault address when the request
is not successful.
Signed-off-by: Haren Myneni <haren@linux.ibm.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
Link: https://lore.kernel.org/r/0315251705baff94f678c33178491b5008723511.camel@linux.ibm.com
