set_* functions involve left shift of param values into respective
register fields before writing to register. Similarly get_* functions
involve right shift to extract values from the respective bit fields.
Replace these explicit shifting statements with standard kernel style
macros FIELD_GET() and FIELD_PREP().
Signed-off-by: Akshay Jindal <akshayaj.lkd@gmail.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Introduce formula-based macros to compute GEN INTR configuration register
addresses from the interrupt number and register index. This reduces the
need for 22 explicit register macros to three base definitions.
Add a centralized lookup table keyed by IIO event direction and replace
get_gen_config_reg() with a helper integrated with this table.
Apply these changes across the affected callbacks to ensure consistent
access to generic interrupt registers.
No functional changes are intended.
Signed-off-by: Akshay Jindal <akshayaj.lkd@gmail.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Add macros and enums for configuration values used in generic event
handling for activity and inactivity detection. Replace hard-coded
values in activity_event_en() with the new definitions to make the
configuration explicit.
No functional changes are intended.
Signed-off-by: Akshay Jindal <akshayaj.lkd@gmail.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Reorganize register and field macros to improve consistency with the
datasheet and naming style:
- Move field macros next to their corresponding register macros
- Reorder register macros to follow address order from the datasheet
- Rename field macros to include the register name in the macro name
- Add a _REG suffix to register macros where missing
- Add INT_STAT register fields corresponding to used INT_CONFIG fields
No functional changes are intended.
Signed-off-by: Akshay Jindal <akshayaj.lkd@gmail.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
This is a conversion to device-managed by using devm_iio_device_register()
inside probe function. Previously the bma400 was not put into power down
mode in some error paths in probe where it now is, but that should cause
no harm.
The dev_set_drvdata() call, bma400_remove() function and hooks in the I2C
and SPI driver struct is removed as devm_iio_device_register() function is
used to automatically unregister on driver detach.
Signed-off-by: Jagath Jog J <jagathjog1996@gmail.com>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Link: https://lore.kernel.org/r/20220505133021.22362-4-jagathjog1996@gmail.com
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Add a IIO driver for the Bosch BMA400 3-axes ultra-low power accelerometer.
The driver supports reading from the acceleration and temperature
registers. The driver also supports reading and configuring the output data
rate, oversampling ratio, and scale.
Signed-off-by: Dan Robertson <dan@dlrobertson.com>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
