net: mdio: add a driver for PIC64-HPSC/HX MDIO controller

This adds an MDIO driver for PIC64-HPSC/HX. The hardware supports C22
and C45 but only C22 is implemented in this commit.

This MDIO hardware is based on a Microsemi design supported in Linux by
mdio-mscc-miim.c. However, The register interface is completely
different with pic64hpsc, hence the need for a separate driver.

The documentation recommends an input clock of 156.25MHz and a prescaler
of 39, which yields an MDIO clock of 1.95MHz.

The hardware supports an interrupt pin or a "TRIGGER" bit that can be
polled to signal transaction completion. This commit uses polling.

This was tested on Microchip HB1301 evalkit with a VSC8574 and a
VSC8541.

Signed-off-by: Charles Perry <charles.perry@microchip.com>
Reviewed-by: Maxime Chevallier <maxime.chevallier@bootlin.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Link: https://patch.msgid.link/20260408131821.1145334-3-charles.perry@microchip.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

MAINTAINERS

@@ -17392,6 +17392,12 @@ L:	linux-serial@vger.kernel.org
 S:	Maintained
 F:	drivers/tty/serial/8250/8250_pci1xxxx.c
 
+MICROCHIP PIC64-HPSC/HX DRIVERS
+M:	Charles Perry <charles.perry@microchip.com>
+S:	Supported
+F:	Documentation/devicetree/bindings/net/microchip,pic64hpsc-mdio.yaml
+F:	drivers/net/mdio/mdio-pic64hpsc.c
+
 MICROCHIP POLARFIRE FPGA DRIVERS
 M:	Conor Dooley <conor.dooley@microchip.com>
 L:	linux-fpga@vger.kernel.org

drivers/net/mdio/Kconfig

@@ -145,6 +145,13 @@ config MDIO_OCTEON
 	  buses. It is required by the Octeon and ThunderX ethernet device
 	  drivers on some systems.
 
+config MDIO_PIC64HPSC
+	tristate "PIC64-HPSC/HX MDIO interface support"
+	depends on HAS_IOMEM && OF_MDIO
+	help
+	  This driver supports the MDIO interface found on the PIC64-HPSC/HX
+	  SoCs.
+
 config MDIO_IPQ4019
 	tristate "Qualcomm IPQ4019 MDIO interface support"
 	depends on HAS_IOMEM && OF_MDIO

drivers/net/mdio/Makefile

@@ -20,6 +20,7 @@ obj-$(CONFIG_MDIO_MOXART)		+= mdio-moxart.o
 obj-$(CONFIG_MDIO_MSCC_MIIM)		+= mdio-mscc-miim.o
 obj-$(CONFIG_MDIO_MVUSB)		+= mdio-mvusb.o
 obj-$(CONFIG_MDIO_OCTEON)		+= mdio-octeon.o
+obj-$(CONFIG_MDIO_PIC64HPSC)		+= mdio-pic64hpsc.o
 obj-$(CONFIG_MDIO_REALTEK_RTL9300)	+= mdio-realtek-rtl9300.o
 obj-$(CONFIG_MDIO_REGMAP)		+= mdio-regmap.o
 obj-$(CONFIG_MDIO_SUN4I)		+= mdio-sun4i.o

drivers/net/mdio/mdio-pic64hpsc.c

@@ -0,0 +1,190 @@
+// SPDX-License-Identifier: GPL-2.0
+/* Microchip PIC64-HPSC/HX MDIO controller driver
+ *
+ * Copyright (c) 2026 Microchip Technology Inc. and its subsidiaries.
+ */
+
+#include <linux/bitops.h>
+#include <linux/clk.h>
+#include <linux/io.h>
+#include <linux/iopoll.h>
+#include <linux/kernel.h>
+#include <linux/module.h>
+#include <linux/of_mdio.h>
+#include <linux/platform_device.h>
+
+#define MDIO_REG_PRESCALER     0x20
+#define MDIO_CFG_PRESCALE_MASK GENMASK(7, 0)
+
+#define MDIO_REG_FRAME_CFG_1 0x24
+#define MDIO_WDATA_MASK	     GENMASK(15, 0)
+
+#define MDIO_REG_FRAME_CFG_2	 0x28
+#define MDIO_TRIGGER_BIT	 BIT(31)
+#define MDIO_REG_DEV_ADDR_MASK	 GENMASK(20, 16)
+#define MDIO_PHY_PRT_ADDR_MASK	 GENMASK(8, 4)
+#define MDIO_OPERATION_MASK	 GENMASK(3, 2)
+#define MDIO_START_OF_FRAME_MASK GENMASK(1, 0)
+
+/* Possible value of MDIO_OPERATION_MASK */
+#define MDIO_OPERATION_WRITE BIT(0)
+#define MDIO_OPERATION_READ  BIT(1)
+
+#define MDIO_REG_FRAME_STATUS 0x2C
+#define MDIO_READOK_BIT	      BIT(24)
+#define MDIO_RDATA_MASK	      GENMASK(15, 0)
+
+struct pic64hpsc_mdio_dev {
+	void __iomem *regs;
+};
+
+static int pic64hpsc_mdio_wait_trigger(struct mii_bus *bus)
+{
+	struct pic64hpsc_mdio_dev *priv = bus->priv;
+	u32 val;
+	int ret;
+
+	/* The MDIO_TRIGGER bit returns 0 when a transaction has completed. */
+	ret = readl_poll_timeout(priv->regs + MDIO_REG_FRAME_CFG_2, val,
+				 !(val & MDIO_TRIGGER_BIT), 50, 10000);
+
+	if (ret < 0)
+		dev_dbg(&bus->dev, "TRIGGER bit timeout: %x\n", val);
+
+	return ret;
+}
+
+static int pic64hpsc_mdio_c22_read(struct mii_bus *bus, int mii_id, int regnum)
+{
+	struct pic64hpsc_mdio_dev *priv = bus->priv;
+	u32 val;
+	int ret;
+
+	ret = pic64hpsc_mdio_wait_trigger(bus);
+	if (ret)
+		return ret;
+
+	writel(MDIO_TRIGGER_BIT | FIELD_PREP(MDIO_REG_DEV_ADDR_MASK, regnum) |
+		       FIELD_PREP(MDIO_PHY_PRT_ADDR_MASK, mii_id) |
+		       FIELD_PREP(MDIO_OPERATION_MASK, MDIO_OPERATION_READ) |
+		       FIELD_PREP(MDIO_START_OF_FRAME_MASK, 1),
+	       priv->regs + MDIO_REG_FRAME_CFG_2);
+
+	ret = pic64hpsc_mdio_wait_trigger(bus);
+	if (ret)
+		return ret;
+
+	val = readl(priv->regs + MDIO_REG_FRAME_STATUS);
+
+	/* The MDIO_READOK is a 1-bit value reflecting the inverse of the MDIO
+	 * bus value captured during the 2nd TA cycle. A PHY/Port should drive
+	 * the MDIO bus with a logic 0 on the 2nd TA cycle, however, the
+	 * PHY/Port could optionally drive a logic 1, to communicate a read
+	 * failure. This feature is optional, not defined by the 802.3 standard
+	 * and not supported in standard external PHYs.
+	 */
+	if (!(bus->phy_ignore_ta_mask & 1 << mii_id) &&
+	    !FIELD_GET(MDIO_READOK_BIT, val)) {
+		dev_dbg(&bus->dev, "READOK bit cleared\n");
+		return -EIO;
+	}
+
+	return FIELD_GET(MDIO_RDATA_MASK, val);
+}
+
+static int pic64hpsc_mdio_c22_write(struct mii_bus *bus, int mii_id, int regnum,
+				    u16 value)
+{
+	struct pic64hpsc_mdio_dev *priv = bus->priv;
+	int ret;
+
+	ret = pic64hpsc_mdio_wait_trigger(bus);
+	if (ret < 0)
+		return ret;
+
+	writel(FIELD_PREP(MDIO_WDATA_MASK, value),
+	       priv->regs + MDIO_REG_FRAME_CFG_1);
+
+	writel(MDIO_TRIGGER_BIT | FIELD_PREP(MDIO_REG_DEV_ADDR_MASK, regnum) |
+		       FIELD_PREP(MDIO_PHY_PRT_ADDR_MASK, mii_id) |
+		       FIELD_PREP(MDIO_OPERATION_MASK, MDIO_OPERATION_WRITE) |
+		       FIELD_PREP(MDIO_START_OF_FRAME_MASK, 1),
+	       priv->regs + MDIO_REG_FRAME_CFG_2);
+
+	return 0;
+}
+
+static int pic64hpsc_mdio_probe(struct platform_device *pdev)
+{
+	struct device_node *np = pdev->dev.of_node;
+	struct device *dev = &pdev->dev;
+	struct pic64hpsc_mdio_dev *priv;
+	struct mii_bus *bus;
+	unsigned long rate;
+	struct clk *clk;
+	u32 bus_freq;
+	u32 div;
+	int ret;
+
+	bus = devm_mdiobus_alloc_size(dev, sizeof(*priv));
+	if (!bus)
+		return -ENOMEM;
+
+	priv = bus->priv;
+
+	priv->regs = devm_platform_ioremap_resource(pdev, 0);
+	if (IS_ERR(priv->regs))
+		return PTR_ERR(priv->regs);
+
+	bus->name = KBUILD_MODNAME;
+	bus->read = pic64hpsc_mdio_c22_read;
+	bus->write = pic64hpsc_mdio_c22_write;
+	snprintf(bus->id, MII_BUS_ID_SIZE, "%s", dev_name(dev));
+	bus->parent = dev;
+
+	clk = devm_clk_get_enabled(dev, NULL);
+	if (IS_ERR(clk))
+		return PTR_ERR(clk);
+
+	if (of_property_read_u32(np, "clock-frequency", &bus_freq))
+		bus_freq = 2500000;
+
+	rate = clk_get_rate(clk);
+
+	div = DIV_ROUND_UP(rate, 2 * bus_freq) - 1;
+	if (div == 0 || div & ~MDIO_CFG_PRESCALE_MASK) {
+		dev_err(dev, "MDIO clock-frequency out of range\n");
+		return -EINVAL;
+	}
+
+	dev_dbg(dev, "rate=%lu bus_freq=%u real_bus_freq=%lu div=%u\n", rate,
+		bus_freq, rate / (2 * (1 + div)), div);
+	writel(div, priv->regs + MDIO_REG_PRESCALER);
+
+	ret = devm_of_mdiobus_register(dev, bus, np);
+	if (ret) {
+		dev_err(dev, "Cannot register MDIO bus (%d)\n", ret);
+		return ret;
+	}
+
+	return 0;
+}
+
+static const struct of_device_id pic64hpsc_mdio_match[] = {
+	{ .compatible = "microchip,pic64hpsc-mdio" },
+	{}
+};
+MODULE_DEVICE_TABLE(of, pic64hpsc_mdio_match);
+
+static struct platform_driver pic64hpsc_mdio_driver = {
+	.probe = pic64hpsc_mdio_probe,
+	.driver = {
+		.name = KBUILD_MODNAME,
+		.of_match_table = pic64hpsc_mdio_match,
+	},
+};
+module_platform_driver(pic64hpsc_mdio_driver);
+
+MODULE_AUTHOR("Charles Perry <charles.perry@microchip.com>");
+MODULE_DESCRIPTION("Microchip PIC64-HPSC/HX MDIO driver");
+MODULE_LICENSE("GPL");